C-bcitridces – Garmin 210 User Manual

Page 70

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SECTION

C-BCITRIDCES

Insaling & Removing

Ciiiliiiiges

The GARMIN GPSMAP system uses G-chart™ digital cartography to display

nautical charts on-screen. G-chart™ cartridges are installed in the card slot
located at the bottom right of the GPSMAP unit. G-chart™ cartridges may
be installed or removed at any time, whether the unit is on or off.

To install a G-chart™ cartridge:

1. Turn the latch ring 1/4 turn counterclockwise and open the cartridge door.

2. Insert the card (label facing front and G-chart™ logo at top) into the slot.

3. Use your thumb to firmly push the cartridge into place, until the cartridge will

not go any further into the unit If your GPSMAP is on, a confirmation tone will

sound when the cartridge has been properly installed and accepted.

4. Close the cover and turn the latch ring 1/4 turn clockwise to secure. The car

tridge cover features a sealing gasket to keep the G-chart™ area waterproof.

If you insert a G-charf* cartridge and get a 'card format not recognized' message,

try removing the card and reinserting it If the card is still not recognized, contact the

dealer you purchased it from for assistance. G-charf* cartridges are not water

proof, and should not be exposed to moisture or excessive static charges.

To remove a G-chart™ cartridge:

1. Turn the latch ring 1/4 turn counterclockwise and open the cartridge door.

2. Grasp the card atthe bottom groove and pull firmly to remove.

3. If your GPSMAP is on, a confirmation tone will sound when the G-chart™

cartridge has been removed.