Garmin 210 - Manual (Page 31)

The second section of the Map Page is the data window, located at the right
side of the screen display. The data window provides a digital display of navi­
gation data in relation to your present position, the cursor position or a
particular waypoint.
The top field of the data window is the destination field, which displays the
bearing and distance to the destination waypoint indicated, with crosstrack
error (XTK) and turn value (TRN) shown at the bottom of the field. If there is
not an active destination waypoint, ‘Not Active’ will be indicated in the desti­
nation field. The XTK value is the distance you are off a desired course, while
TRN represents the direction in degrees between the bearing to your destina­
tion and your course over ground (COG). Whenever the cursor is in use, the
destination field will display the distance and bearing from your present
position to the cursor.
The speed and course field, located below the destination field, displays
your present speed and course over ground (SOG and COG). Directly below
this field are the arrival and status fields. The arrival field displays your veloci­
ty made good (VMG) and estimated time enroute (ETE). VMG is the speed
you are closing in on a destination along the desired track, with the ETE rep­
resenting the total time left to your destination based on your current VMG.
Whenever the cursor is in use, the arrival field will be replaced by a position
field, which displays the coordinates of the cursor.
The status field, located directly below the arrival field, indicates the operat­
ing mode and map scale currently in use. When the cursor is used to ‘snap’ to
an on-screen waypoint or navaid, the arrival and status fields will be replaced
with a waypoint review field, showing the name, position, icon and comment
for the selected on-screen position.
M№ PAGE
Data Witidmt’
Destination
Field
Speed &
Course
Field
Arrival
Field
Status
Field