Rice Lake 520 HMI Digital Weight Indicator Installation Manual - Manual (Page 28)

Configuration 22
3.2.2 Format Menu
9999999 9999999 9999999 9999999
%41%*7 .6-5 6/*54 %&$1/5
%
%
% OVNCFS
13*."3 4&$/%3
$0.."
%05
%&$'.5
%41%*7 6/*54 %&$1/5
(
,(
%
%
%
-#
5/
0;
(/
5
"-(065 %*(*/ 4&5154 130(3. 1'03.5 4&3*"- $"-*#3 $0/'*( '03."5
-5
/0/&
(
,(
5/
0;
(/
5
-5
/0/&
-#
4&$
4&$
4&$
.4
4&$
.4
.4
.4
.4
4&$
%413"5&
4&$
7&34
Figure 3-6. Format Menu
DFTHRH 5DD
10DD
20DD
50DD
100DD
200DD
250DD
NONE
2DD Digital filter cutout threshold. Specifies the filter threshold, in display divisions. When a
specified number of consecutive scale readings (DFSENS parameter) fall outside of this
threshold, digital filtering is suspended. If NONE is selected, the filter is always enabled.
PWRUPMD GO
DELAY Power up mode. In GO mode, the indicator goes into operation immediately after a brief
power up display test.
In DELAY mode, the indicator performs a power up display test, then enters a 30-second
warm up period. If no motion is detected during the warm up period, the indicator becomes
operational when the warm up period ends; if motion is detected, the delay timer is reset
and the warm up period repeated.
SCRNSV OFF
DIM
DELAY Screen saver mode. Possible values are:
OFF: Display remains at brightest setting. Use for bright environments.
DIM: Display is dimmed to half brightness. Use for darker environments.
DELAY: Display is dimmed after an interval of about 15 minutes if no key is pressed and
no scale motion is detected. Display is restored to full brightness and the screen saver
timer restarted by any key press or scale motion.
TAREFN BOTH
NOTARE
PBTARE
KEYED Enables or disables push-button and keyed tares. Possible values are:
BOTH: Both push-button and keyed tares are enabled
NOTARE: No tare allowed (gross mode only)
PBTARE: Push-button tares enabled
KEYED: Keyed tare enabled
CONFIG Menu
Parameter Choices Description
Table 3-2. Configuration Menu Parameters (Continued)