KMC Controls TPE–1464 Series(2004-2008) - Manual (Page 3)

Installation Guide
Gage Pressure Transducer
TPE-1464 Series
Mounting
Avoid locations with severe vibrations or excessive
moisture. The enclosure has a standard ½" conduit
opening and may be installed with either a conduit
coupler or a cable gland type fitting.
1. Mount on a vertical surface with the pressure
port and cable entrance on the bottom.
2. Use screws in the tab holes to fasten the
assembly to the mounting surface.
3. Ensure there is enough space around the unit to
make the pressure and electrical connections.
WARNING:
Do not use in explosive or hazardous environments, with combustible or flammable gasses, as a safety or
emergency stop device, or in any other application where failure of the product could result in personal
injury.
!CAUTION:
Use electrostatic discharge precautions during installation and do not exceed device ratings.
Plumbing
1. Use an appropriately rated pressure tubing for connections.
2. Arrange the tubing to minimize stress on the connections.
3. Do not allow debris to fall into the pressure ports, contamination can damage the sensor.
Valid late 2004 into 2008—see Rev. A
of this installation guide for information
on the new case and board.