Elecraft P3 High-Performance Panadapter Manual - Manual (Page 57)

57
Gather the ribbon cable into neat folds and place the clip on the cable to hold it in place as shown in Figure
21. The clip has ridges to grip the cable tightly. Use gentle folds. Avoid creasing the cable.
Figure 21. Placing Clip on the Ribbon Cable.
Slide the ribbon cable through the clip to adjust the folds so the clip lies near the side panel without being
pulled away by the cable (see Figure 22).
Check the area of the side panel behind the clip to ensure it is free of dirt or oil that would interfere with the
adhesive on the clip. Clean as necessary with a soft wipe moistened with a non-residue cleaner such as glass
cleaner. Dry thoroughly.
Remove the paper backing from the adhesive side of the clip and press it against the side panel as
shown in Figure 22.
Figure 22. Clip Mounted on Side Panel.