Elecraft P3 High-Performance Panadapter Manual - Manual (Page 49)

49
At the front end of the bottom cover, install the two feet and tilt stand as shown in Figure 9. Place the tilt
stand with the ends inserted into the holes in the feet as shown before attaching the feet to the bottom cover. Use
4-40 7/16” (11 mm) zinc pan head screws with inside tooth lock washers and nuts just as you did for the rear
feet.
Figure 9. Installing the Tilt Stand.
At the mid-point along each side of the bottom and top covers is a screw hole. Mount the four angle
brackets in these holes as shown in Figure 10. Be sure all six holes of each cover have clean metal on the inside
surface. Do not remove paint on the outside surface! Be sure to use pan head screws on the bottom cover
brackets and flat head screws on the top cover brackets. The holes in the top cover are counter sunk for the flat
head screws. Check to ensure the brackets are oriented as shown. If you install the bracket backwards the case
parts will not fit correctly.
Figure 10. Installing Angle Brackets on the Covers.
Set the top and bottom covers aside in a safe place.