Elecraft P3 High-Performance Panadapter Manual - Manual (Page 50)

50
Locate the back cover. Check the area on the inside of the cover around each of the holes to ensure bare
metal will contact the fasteners and connectors.
Locate the hole cover. It is a transparent strip on a paper backing with adhesive that fits over the Sensor,
Keyboard, Ext Display and Aux data holes on the back cover. Do not break the strip on the perforations. They
are provided to allow you to easily remove individual sections as needed later. Remove the backing paper and
place the strip on the inside surface of the back cover, aligned so the two round holes are over the corresponding
holes above and below the EXT DISP connector opening in the cover and press it firmly in place (see Figure
11). There is no adhesive over the areas that cover the openings so dust and dirt will not adhere to it.
Figure 11. Installing the Hole Cover.
If you have the optional P3SVGA board to install at this time, remove a portion of the hole cover as shown
in Figure 11. Installing the Hole Cover.
Do this ONLY if you have the Optional P3SVGA board to install at this time.
Figure 12. Preparing the Hole Cover to Install the P3SVGA Board.