Dell PowerVault MD3220 - Manual (Page 76)

76 Configuration: About Your Storage Array
To change the enclosure order in the Physical pane:
1 In the AMW, select Storage Array Change Enclosure Order.
2 From the enclosures list, select the enclosure you want to move and click
either Up or Down to move the enclosure to the new position.
3 Click OK.
If you have set a password for the selected storage array, the Enter
Password dialog is displayed.
4 Type the current password for the storage array.
5 Click OK.
Configuring Alert Notifications
MDSM can send an alert for any condition on the storage array that requires
your attention. Alerts can be sent as e-mail messages or as Simple Network
Management Protocol (SNMP) trap messages.
You can configure alert notifications either for all the storage arrays or a single
storage array.
To configure alert notifications for all storage arrays:
1 In the EMW, select the Setup tab.
2 Select Configure Alerts.
The Configure Alerts dialog is displayed.
3 Select All storage arrays.
4 Click OK.
The Configure Alerts dialog is displayed. To configure e-mail alerts, see
"Configuring E-mail Alerts" on page 77. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 79.
To configure alert notifications for a single storage array:
1 In the EMW, select the Devices tab.
2 Select the relevant storage array, then select EditConfigure Alerts.
The Configure Alerts dialog is displayed. To configure e-mail alerts, see
"Configuring E-mail Alerts" on page 77. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 79.
book.book Page 76 Tuesday, June 18, 2013 2:53 PM