Dell PowerVault MD3220 - Manual (Page 260)

260 Troubleshooting: Your Array
Troubleshooting a Wet Storage Array
CAUTION: Many repairs may only be done by a certified service technician.
You must only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Turn off the array and disconnect all the cables.
2 Remove the following components from the array. See "Management:
Installing Array Components" on page 201.
• Hard drives
• RAID controller modules
• Power supply/cooling fan modules
• Control panel
• Backplane
3 Let the system dry thoroughly for at least 24 hours.
4 Reinstall the components you removed in step 2.
5 Connect all the cables and turn on the array.
If the array does not start properly, see "Getting Help" on page 265.
book.book Page 260 Tuesday, June 18, 2013 2:53 PM