Dell PowerVault MD3220 - Manual (Page 183)

Configuration: Device Mapper Multipath for Linux 183
DELL
is the vendor of the device
MD3200
is the model of the device
Sdx
is the physical path to the owning controller for the device
Sdcl
is the physical path to the non-owning controller for the device
Create a New fdisk Partition on a Multipath Device Node
The fdisk command allows you to create partition space for a file system on
the newly scanned and mapped virtual disks that are presented to Device
Mapper.
To create a partition with the multipathing device nodes
/dev/mapper/mpath, for example, use the following command, where
mpath is the multipathing device node on which you want to create the
partition:
# fdisk /dev/mapper/mpath
NOTE: The value is an alphanumeric operating system dependent format. The
corresponding value for mapped virtual disks can be seen using the previously run
multipath
command. Please see your operating system documentation for
additional information on fdisk usage.
Add a New Partition to Device Mapper
The kpartx command adds the newly fdisk created partition to the Device
Mapper list of usable partitions. See examples below, where mpath is the
device node on which the partition was created.
# kpartx –a /dev/mapper/mpath
If successful, the command does not show an output. To verify success and
view exact partition naming, the user can use these commands to see the full
partition names assigned.
# cd /dev/mapper
# ls
The following examples provide information about the general mapping
formats:
On RHEL hosts, a partition node has the format
/dev/mapper/mpathp, where is the alphabetic number for the
multipathing device, is the partition number for this device.
book.book Page 183 Tuesday, June 18, 2013 2:53 PM