Dell PowerVault MD3220 - Manual (Page 249)

Troubleshooting: Your Storage Array Software 249
b Make sure that the network can access the host by using the ping
command in the following syntax:
ping
.
If the network can access the host, continue to step c. If the network
cannot access the host, go to step d.
c Remove the host with the unresponsive status from the MDSM, and
add that host again.
If the host returns to optimal status, you have completed this
procedure.
d Make sure that the power to the host is turned on and that the host is
operational.
e If applicable, make sure that the host bus adapters are installed in the
host.
f Examine all external cables and switches or hubs to make sure that
you cannot see any damage and that they are tightly connected.
g If you have recently replaced or added the controller, restart the host
context agent software so that the new controller is found.
If a problem exists, make the appropriate modifications to the host.
4 If you have an out-of-band storage array, use the following procedure. Click
Refresh after each step to make sure of the results:
a Make sure that the network can access the controllers by using the
ping command. Use the following syntax:
ping
If the network can access the controllers, continue to step b. If the
network cannot access the controllers, go to step c.
b Remove the storage array with the unresponsive status from MDSM,
and add that storage array again.
If the storage array returns to optimal status, you have completed this
procedure.
book.book Page 249 Tuesday, June 18, 2013 2:53 PM