Cyclades User's Guide - Manual (Page 92)

Setting Up the KVM/net
76 AlterPath KVM/net Installation, Administration, and User’s Guide
T To Mount the KVM/net
1. Decide whether you need to mount the KVM/net by the front or back and
locate the appropriate sets of holes on the KVM/net.
Figure 2-1:Rack Mounting Holes on the KVM/net
2. Connect the two supplied brackets to the KVM/net, connecting one bracket
to each side of the box.
3. For each bracket, insert a screw through each of the three holes on the
bracket into the appropriate holes at either the front or back of the KVM/net.
The following figure shows the bracket flanges on the front of the KVM/net after the brackets
are installed.
4. Use a Phillips screwdriver to tighten the screws.
Bracket
KVM/net side
Holes for front mounting Holes for back mounting
Brackets