Cyclades User's Guide - Manual (Page 461)

445
How to Disable Mouse Acceleration Using
Windows Registry
In order to disable the mouse acceleration and synchronize it on your PC or
laptop with the remote server attached to KVM/net, run
regedit on the
remote server, and disable the mouse acceleration by setting the mouse speed
to “0”.
The following registry entries shows the path where the “MouseSpeed”
setting is located.
This key is listed twice in the registry file and is usually set to 1 (enabled) by
default. After changing the value of this key, log off and on to the server or
reboot the server to get the registry changes to take effect.
Note: The above procedure is for a Windows server. Also, See “Disabling Mouse
Acceleration” on page 106 for configuration procedures using the Windows
Control Panel.
HKEY_USERS\\.Default\\Control Panel\\Mouse\\MouseSpeed = 0
HKEY_CURRENT_USER\\Control Panel\\Mouse\\MouseSpeed = 0