Cyclades User's Guide - Manual (Page 452)

436 AlterPath KVM/net Installation, Administration, and User’s Guide
T To Save the zImage into the KVM/net’s Flash Memory.
1. Download the latest firmware from the Cyclades FTP server at ftp://
ftp.cyclades.com/ and save it on your FTP Server.
Note: Make sure to set the transfer mode to binary (bin).
2. Save the file onto your FTP server. In the following example the filename
is zImage_kvm_200.bin
3. Connect a terminal to the console port on your KVM/net, login as “root”,
and go to the following directory.
4. From this directory, ftp to your FTP server.
Note: Be sure to set the transfer mode to binary (bin).
5. Exit ftp when the download is completed.
6. Reboot the KVM/net.
Note: If the unit does not reboot properly, there may have been a file corruption.
Repeat the steps described in section "To Boot From TFTP"
[root@)KVM/net root]# cd /proc/flash
[root@KVM/net flash]#
[root@KVMNet flash]# ftp
ftp> bin [enter]
ftp> get zImage_kvm_200.bin [enter]
[root@KVM/net flash]# reboot