Cyclades User's Guide - Manual (Page 154)

Common Features of Administrators’ Windows
138 AlterPath KVM/net Installation, Administration, and User’s Guide
For procedures specific to each mode, see “Administrative Modes” on page
141.
T To Log In to the Web Manager as Admin
This procedure assumes that the prerequisites described under “Prerequisites
for Using the Web Manager” on page 19 are done and that you can connect to
the Web Manager.
1. To bring up the Web Manager, enter the IP address of the KVM/net in the
address (URL) field of a supported browser on a computer running a
Windows operating system.
Note: Devices like the AlterPath KVM/net that are installed in computer rooms are
usually assigned fixed IP addresses. If DHCP is enabled, you must find out
the dynamically assigned IP address each time before you bring up the Web
Manager. Check with the administrator who configured the basic network
parameters on the KVM/net, for help finding the IP address, if needed. Or see
“Considerations When Choosing Whether to Enable DHCP” on page 57 for a
list of ways to find out the KVM/net IP address assigned by the DHCP server.
a. If DHCP is enabled, enter the dynamically assigned IP address.
b. If DHCP is not enabled, use a fixed IP address assigned by the
administrator to the KVM/net.
The Login page appears. If direct logins to ports is not enabled, a
“username” and a “password” field appear on the login area of the screen,
as shown in the following screen example.