Setting up and configuring power management – Cyclades User's Guide User Manual
Page 58
Power Management
42
AlterPath KVM/net Installation, Administration, and User’s Guide
Setting Up and Configuring Power Management
Administrators most commonly assign power management permissions to
users and configure ports for power management using the Web Manager.
However, the OSD also offers menus for configuring power management on
local devices.
Two types of power management can be set up and configured on the KVM/
net:
•
Power management of any device plugged into an PM connected to the
AUX port.
See “Controlling Power Through the Web Manager IPDU Power
Management Forms” on page 41.
•
Power management while accessing a server connected to a KVM port and
plugged into an PM connected to the AUX port.
See “Controlling Power While Connected to KVM Ports” on page 41.
The following set up and configuration tasks must be performed for both
types of power management:
Table 1-16: Tasks: General Power Management Set Up
Task
Where Documented/Notes
1
Install PM units.
• “To Connect an AlterPath PM to the
• “To Connect Multiple PMs to the KVM/
See the section about installing PMs in the
AlterPath KVM/net Installation,
Configuration, and User’s Guide.
2
Configure the AUX port for use with
power management.
“To Configure the AUX Port for Use With
an IPDU or an External Modem” on page
267