Cyclades User's Guide - Manual (Page 192)

Configuration
176 AlterPath KVM/net Installation, Administration, and User’s Guide
Note: The Port Authentication drop-down menu is disabled by default. To enable,
activate the “Direct Access” check box on the KVM > General form. If the
“Direct Access” check box is greyed out, you need to modify the security
profile to Open, or select the Custom security profile and enable “Access to
KVM Ports” option. See Configuration>Security>Profile form.
Authentication method serves as a direct access authentication to the
connected servers or devices only.
Choice of authentication types for KVM ports are:
• None
• Local
• Kerberos (either Kerberos or Kerberos/DownLocal),
• LDAP (either LDAP or LDAP/DownLocal)
• NTLM (either NTLM Windows NT/2000/2003 or NTLM/DownLocal)
• RADIUS (either RADIUS or RADIUS/DownLocal)
• TACACS+ (either TACACS+, and TACACS+/DownLocal)
“See “Configuring Authentication Servers for Logins to the KVM/net and
Connected Devices” on page 208.” on page 207 for the instructions on
specifying an authentication method.
Local Users and IP Users
Selecting Configuration>KVM>General>User 1 brings up a form with the
fields shown in the following figure.