Cyclades User's Guide - Manual (Page 45)

Introduction 29
Server Access: Inband and Out of Band
• If user jennifer is not a member of any group with a Default Permission
specified, then her access request is passed to decision 6.
Decision 6: Check Generic User’s Default Permissions
Note: If an access request gets this far, the Default Permission of the Generic User is
the only permission that could apply.
6. Does the Default Permission for the Generic User allow access to the port?
• If yes, access is granted.
• If no, access is denied.
Server Access: Inband and Out of Band
KVM/net users can access servers over the Ethernet using the following
methods:
• In-band access – An IP address is used to connect to and control Windows
(Win2000, 2003, XP, and NT) Terminal Servers.
• Out-of-band access – KVM ports are used to connect to PCs with USB or
PS/2 connectors or Sun servers with USB connectors.
The differences between the in-band and out-of-band connection methods are
briefly described in the following table. For a more detailed description of the
requirements and functionality of each connection method, see the following
section, “Determining the Connection Type and its Supported Functionality”
on page 31.
Table 1-11: In-band and Out of Band Connections
In-band Out-of-Band
Connection Type Remote Desktop Protocol
(RDP) over the Ethernet or PPP Keyboard, video, mouse (KVM)
CAT5 connection to a KVM/net
and Ethernet or PPP access to
the KVM/net Web Manager