Garmin GNS 430 - Manual (Page 87)

79
Vectors to Final
Let’s take a second look at the “VOR 22” approach into Billard Municipal. Instead of
following the DME arc, ATC tells you to expect vectors onto the fi nal approach course.
There are several ways to select “vectors to fi nal” with the GNS 430. The fi rst two op-
tions below will normally require the least workload to accomplish:
• When the approach is first selected, choose “VECTORS” from the transitions
window.
• Load a full approach — including the IAF from the transitions window — as
described on page 66. When cleared, press P and select “Activate Vectors-To-
Final?”. (See page 67.)
• Load the full approach as described on page 66. Use the D key (by pressing it
twice) from the active flight plan page to select the desired leg of the approach.
(See page 65.)
To select “VECTORS” from the transitions window:
1. Select Billard Municipal (KTOP) as your destination, using the D key, or as the last way-
point in a flight plan.
2. Press the P key and select the “VOR 22” approach using the steps outlined on page 66.
3a. From the transitions window, select “VECTORS”.
4a. Select “Load?” (or “Activate?”, if already cleared for the approach).
To activate vectors-to-final from the procedures page:
1. Select Billard Municipal (KTOP) as your destination, using the D key or as the last way-
point in a flight plan.
2. Press the P key and select the “VOR 22” approach using the steps outlined on page 66.
3b. From the transitions window, select “D258G” as the IAF. Also, select “Load?”.
4b. When cleared, press the
P key and select “Activate Vector-To-Final?”.
5
PROCEDURES
Vectors-To-Final
Approach Example
q
b
p
b
p a
190-00140-00.indd 79 5/7/2003, 5:17:17 PM