Garmin GNS 430 - Manual (Page 61)

53
Cancelling Direct-To Navigation
Once a direct-to is activated, the GNS 430 will provide navigation guidance to the
selected destination until the direct-to is replaced with a new direct-to or flight plan,
cancelled, or the unit is turned off.
To cancel a direct-to:
1. Press the D key to display the select direct-to waypoint page.
2a. Press m to display the direct-to options menu.
3a. With “Cancel Direct-To NAV?” highlighted, press E . If a flight plan is still active, the GNS
430 will resume navigating the flight plan along the closest leg.
Specifying a Course to a Waypoint
Whenever you perform a direct-to, the GNS 430 will set a direct great circle course
to your selected destination. You can also manually defi ne the course to your destination,
using the “CRS” course fi eld on the select direct-to waypoint page.
To manually define the direct-to course:
1. Press the D key.
2b. Use the small ( a ) and large ( d ) right knobs to select the destination waypoint.
3b. Press E to confirm the selected waypoint, then rotate the large right knob ( d ) to highlight
the course (“CRS”) field.
4. Rotate the small ( a ) and large ( d ) right knobs to select the desired course and press
E .
5. Press E again to begin navigation using the selected destination and course.
6. To reselect a direct course from present position (or select a new manually-defined course),
simply press D , followed by E twice.
3
DIRECT TO
Cancelling &
Manual Course
q
p
b
o
a
p
a
190-00140-00.indd 53 5/7/2003, 5:16:50 PM