Flight plans, Qn o p – Garmin GNS 430 User Manual
Page 66
58
Flight Plan Catalog Options
The following options (some covered on the preceding pages) are available for the
flight plan catalog:
Activate Flight Plan? allows you to select the flight plan for navigation guidance, as
described on page 56.
Invert & Activate FPL? allows you to reverse the highlighted flight plan and select
it for navigation guidance, as described on page 56.
Create New Flight Plan? allows you to create a new flight plan, as described
on page 54.
Crossfill? allows you to transfer a direct-to destination, the active flight plan, any
stored flight plan or user waypoints to a second 400-Series or 500-Series Garmin
unit. Some crossfill operations can be done automatically. If both units are set to
“auto”, a change in the direct-to destination or active flight plan on one unit will also
be seen on the other.
For additional information, please see page 142.
To crossfill flight plans between two 400- or 500-Series Garmin units:
1. Select the “Crossfill?” option from the flight plan catalog options and press
E
.
2. Rotate the large right knob (
d
) to select the “Method” field.
3. Rotate the small right knob (
a
) to select “Auto” or “Manual” and press
E
. “Auto” will
automatically transfer the active flight plan or direct-to selection to another 400- or 500-series
Garmin unit, without user intervention.
4. If “Manual” is selected: Rotate the large right knob (
d
) to select the “Transfer” field, then
rotate the small right knob (
a
) to select the type of information to transfer between units
(active flight plan, flight plan, all user waypoints or a single user waypoint). When “Flight
Plan” or “User Waypoint” is selected, a second field will appear to the immediate right of the
“Transfer” field. Use the small (
a
) and large (
d
) right knobs to enter the number of the
flight plan or the name of the user waypoint you wish to transfer.
5. The “Cross-Side” field allows you to designate the sending and receiving units in a crossfill
operation. Rotate the large right knob to select the “Cross-Side” field, then rotate the small
right knob (
a
), to select “To” or “From”. Press
E
to confirm the selection.
6. Rotate the large right knob (
d
) to highlight “Initiate Transfer?” and press
E
.
FLIGHT PLANS
Flight Plan
Catalog Options
4
q
n
o
p
190-00140-00.indd 58
5/7/2003, 5:16:55 PM