Aux pages – Garmin GNS 430 User Manual
Page 156
148
AUX PAGES
Utility Page
9
Utility Page: Flight Timers
To view, use or reset the generic timer:
1. Select “Flight Timers” from the utility page, using the steps described on page 145.
2. The flashing cursor highlights “Start?”. To start the generic timer, press
E
. (You will typically
begin with this step for count up timers. However, for count down timers, you may wish to enter
a count direction and time before starting the timer. See below.)
3a. To change the count direction, rotate the large right knob (
h
) to highlight count direction field:
“Down” or “Up”. Rotate the small right knob (
a
) to select the desired count direction. Press
E
when finished.
4. For a count down timer, rotate the large right knob (
h
) to highlight the time field. Use the
small (
a
) and large (
h
) right knobs to enter the count down time—in hours, minutes and
seconds. Press
E
when finished.
5. To stop the generic timer, rotate the large right knob (
h
) to highlight “Stop? and press
E
.
6. To reset the generic timer, rotate the large right knob (
h
) to highlight the time field. Press
c
, followed by
E
.
To record or reset the departure time:
1. Select “Flight Timers” from the utility page, using the steps described on page 145.
2. Rotate the large right knob (
h
) to highlight the reset mode field, under “Departure Time”.
(The reset mode field will indicate “Pwr-on” or “GS>30kt”.)
3b. Rotate the small right knob (
a
) to select the desired reset mode. (“Pwr-on” will record a
departure time when the GNS 430 is turned on. “GS>30kt” will record a departure time once
the GPS-computed ground speed exceeds 30 knots.)
4. Press
E
when finished.
5. To reset the departure time, rotate the large right knob (
h
) to highlight “Reset?” and press
E
.
p
b
p
a
n
190-00140-00.indd 148
5/7/2003, 5:18:22 PM