Garmin GNS 430 - Manual (Page 141)

133
To select a VLOC frequency from the VOR or nearest VOR pages:
1. Select the desired page from the main pages. (See page references on the preceding page.)
2. Press the small right knob ( r ) momentarily to activate the flashing cursor
3a. Rotate the large right knob ( d ) to highlight the frequency for the desired VOR.
4. Press E to place the frequency in the standby field of the VLOC window.
5. Press V to activate the selected frequency.
6. Press the small right knob ( r ) to remove the flashing cursor.
When selecting a VOR or ILS approach, manual tuning of the VLOC receiver is not
required. Once the approach procedure is “Loaded” or “Activated”, the GNS 430 will au-
tomatically place the proper frequency in the standby fi eld of the VLOC window. If you
wish to use this frequency, simply press
V
to activate the frequency. Additional informa-
tion on approach procedures is provided in Section 5, beginning on page 66.
To select an approach and automatically tune the proper VLOC frequency:
1. Select the destination airport using the D key or as the last waypoint in the active flight
plan.
2. Press the P key to display the procedures page.
3b. Rotate the large right knob ( d ) to highlight “Select Approach?” and press E .
{continued}
VLOC RECEIVER
Auto-tuning
8
NOTE
For duplex COM operations, the VLOC receiver may be auto-tuned from
the nearest flight service station page. See page 126 for more info.
p
b
q
p a
190-00140-00.indd 133 5/7/2003, 5:18:08 PM