John Deere 318 - Manual (Page 77)

IMPORTANT: Pump shaft and bearing assembly
could restrict movement of swashplate.
Full swashplate movement is
approximately 25 mm (1 in.) in each
direction. If necessary tap shaft with a
soft faced hammer.
2. Push top of swashplate (C) down until it contacts the
stops in the housing.
IMPORTANT: DO NOT drive pins after they bottom.
Housing damage will result.
3. Drive pin (B) until it bottoms in housing.
A—Trunnion Shaft
B—Spring Pin
4. Drive two pins (D) until the lower one bottoms in
C—Pump Swashplate housing.
D—Spring Pin (2 used)
E—Control Shaft
5. Turn swashplate to the neutral position. Pins should
F—Motor Housing
fall into housing.
6. Repeat the above steps to remove second pin (D).
7. Remove control shaft (E) and trunnion shaft (A) to
remove swashplate.
8. Inspect swashplate and motor housing (F).
M36525
-UN
-25JAN90
9. Remove pump shaft.
M36119
-UN
-29AUG88
5M3,5005K,Z -19-18DEC87
M45,5005A,58 -19-11JAN85
Transmission/Disassemble
TM1590 (17MAY95)
50-05-17
316, 318 & 420 Lawn and Garden Tractors
020895
50
05
17