John Deere 318 - Manual (Page 233)

NOTE: Bearing cones are press-fit on output shaft.
Remove bearings only if replacement is
necessary.
Bearing cones and cups are matched and must
be replaced as complete assemblies.
20. Inspect bearing cones (A and D) for wear or
damage. Replace if necessary.
21. Press output shaft (B) from bearing cone (A).
Remove snap ring (C).
22. Remove bearing cone (D) from output shaft (B) using
a knife-edge puller and a press.
23. Remove bevel gear (E), snap ring (F) and key (G).
24. Inspect all parts for wear or damage. Replace as
necessary.
A—Bearing Cone
B—Output Shaft
C—Snap Ring
D—Bearing Cone
E—Bevel Gear
F—Snap Ring
G—Key
Output Shaft Assembly
M77320
-UN
-24FEB95
MX,15908015,5 -19-29MAR95
Mower Gear Case Repair/50-Inch Mower
TM1590 (17MAY95)
80-15-5
316, 318 & 420 Lawn and Garden Tractors
020895
80
15
5