beautypg.com

John Deere 318 User Manual

Page 249

background image

12. Remove vent plug (A) from retainer (G).

13. Remove four cap screws (B). Remove retainer (G)
and output shaft assembly (K) by tapping on end of shaft
with a rubber mallet.

14. Remove output shaft assembly (K) from retainer (G).

15. Remove O-ring (F) and shim (C) from retainer (G).

IMPORTANT: Remove and discard crush ring (E). A

new crush ring must be installed
during assembly to achieve proper
output shaft end play.

16. Remove bearing cup (D) and crush ring (E). Discard
crush ring.

17. Pry out seal (H).

NOTE: Bearing cup is press-fit in gear case. Remove

bearing cup only if replacement is necessary.

Bearing cones and cups are matched and must
be replaced as complete assemblies.

18. Inspect bearing cups (D and I) for wear or damage.

Output Shaft Side

Replace as necessary.

19. Remove bearing cup (I) using a brass drift or punch

A—Vent Plug

and hammer.

B—Cap Screw (4 used)
C—Shim (as required)
D—Bearing Cup
E—Crush Ring
F—O-Ring
G—Retainer
H—Seal
I—Bearing Cup
J—Gear Case
K—Output Shaft Assembly

M77314

-UN

-24FEB95

MX,15908015,22 -19-13MAR95

Mower Gear Case Repair/Later 60-Inch Mower (Peerless)

TM1590 (17MAY95)

80-15-21

316, 318 & 420 Lawn and Garden Tractors

020895

80

15

21

This manual is related to the following products: