John Deere 318 - Manual (Page 250)

NOTE: Bearing cones are press-fit on output shaft.
Remove bearings only if replacement is
necessary.
Bearing cones and cups are matched and must
be replaced as complete assemblies.
20. Inspect bearing cones (A and D) for wear or
damage. Replace if necessary.
21. Press shaft (C) from bearing cone (A). Remove snap
ring (B).
22. Remove bearing cone (D) from shaft (C) using a
knife-edge puller and a press.
23. Remove shims (E), bevel gear (F), snap ring (G) and
key (H).
24. Inspect all parts for wear or damage. Replace as
necessary.
A—Bearing Cone
B—Snap Ring
C—Output Shaft
D—Bearing Cone
E—Shims (as required)
F—Bevel Gear
Output Shaft Assembly
G—Snap Ring
H—Key
M77315
-UN
-24FEB95
MX,15908015,23 -19-13MAR95
Mower Gear Case Repair/Later 60-Inch Mower (Peerless)
TM1590 (17MAY95)
80-15-22
316, 318 & 420 Lawn and Garden Tractors
020895
80
15
22