Unitec POS4000 - Manual (Page 9)

P O S 4 0 0 0
Document Number: POS4010 QSG-3
Document Title: Remote Code POS4000 Installation and Operations Manual
The following commands are lists of steps that would typically be performed on a new
POS4000 prior to use. For further information, see Section 4, Management Operations.
ENABLE REMOTE CODE (At Primary/Master POS4000)
[CMD]
[SYSTEM SETUP]
[3]
(password 3)
[ENTER]
[MENU UP/DOWN] until "Remote Code" is displayed
[ENTER]
[1] (Enable)
[ENTER]
SET DATE AND TIME
Example to set time to Monday 04:30PM on 05/06/08:
[CMD]
[SYSTEM SETUP]
[3]
(password 3)
[ENTER]
[MENU UP/DOWN] until "Set System Time" is displayed
[ENTER]
[0][5][0][6][0][8][1][6][3][0]
[ENTER]
[2]
(Monday)
[ENTER]
NAME WASH FEATURES
Example to change the name of feature 1 to "ECONO-WASH":
[CMD]
[FEATURE
1] (cashier key)
[1] (password 1)
[MENU UP/DOWN] until "Change Wash Name" appears
[ENTER]
[E][C][O][N][O][-][W][A][S][H]
[ENTER]
Note:
To type [-] you must press [SHIFT] to switch to upper characters then [-] (on the [R]
key) then [SHIFT] again to return to the lower characters).
CONFIGURE GROUPS (Not used in all configurations)
Example to set Group 3 to Program 1 and options 1, 2 & 4:
[CMD]
[SYSTEM SETUP]
[3]
(password 3)