Unitec POS4000 - Manual (Page 46)

P O S 4 0 0 0
Document Number: POS4010 26
Document Title: Remote Code POS4000 Installation and Operations Manual
Wash 1 (program 1): Basic $4.00
Wash 2 (program 2): Deluxe $5.00
Wash 3 (program 3): Supreme $6.00
Register is configured to the opposite:
Wash 1 : Supreme $6.00
Wash 2 : Deluxe $5.00
Wash 3 : Basic $4.00
To make the system function properly you must configure POS MAX washes (See Section
3.1.9) to a value of 3 (3 washes). Set Reverse order to 1 (enabled).
After changing these values the current EXT POS settings will print out with a mapping of the
Carwash type given vs. the carwash type requested. This will show the relationship of the
mapping.
If you use groups, you must also set the POS OFFSET (Se Section 6.2.10.1).
This function only works with POS 1 & POS 2.
Example to set Reverse order to Enabled:
[CMD] to select command mode
[2-System Setup] to select "System Setup" menu
[3] Enter your password 3
[ENTER]
[Menu up] Until you see: "Ext. POS MENU->"
[Menu up] Until you see “Reverse order”
[Enter] Select function
[ 1 ][Enter] To enable select 1
3 . 1 . 9 . 6 S e t D e f a u l t D i s c o u n t L e v e l s
Note: This feature is for use with POS 1, 2 and 3.
Setting the default discount levels of the EXTPOS washes will make it so that when the
EXTPOS wash is requesting a code, the accounting will assign a specific discount level to the
purchase. This will happen even though the EXT POS device does not tell the POS4000 the
discount level at which the wash was sold. This feature can only be accomplished C-store
register systems that can do the following:
Allow washes to be sold at pump or register only
Allow the configuration of 6 or more discrete wash types (depending on the discount levels you
need to implement the register may have to accommodate up to 12 wash types)
Whenever this function is accessed, a report will print out to show the mapping of the washes.
Example:
EXT POS will be set up for 12 washes. Carwash has 4 real washes. EXT POS washes are
defined as: