Unitec POS4000 - Manual (Page 69)

P O S 4 0 0 0
Document Number: POS4010 49
Document Title: Remote Code POS4000 Installation and Operations Manual
6 Printer Instructions
The following section provides information on the printers that come with the POS4000. There
are two different models, but both are made by Citizen. If additional information is needed,
consult the complete manual that came with the printer.
6.1 Instructions for Citizen Model CD-S500
Refer to the Citizen CD-S500 operations manual, page 36 for more information on configuring
the printer.
Table 2. Citizen CDS500 Printer Settings
Configuration Settings
Command Type CBM2
Number of Col. 42/35
Font Select 7*9
To configure the printer for operation with the POS4000, perform the following procedure:
1. With the front cover open, turn power on while pressing the FEED button; then release
the FEED button.
2. The POWER LED will flash as the printer enters the maintenance mode; close the front
cover.
3. Press the FEED button until you hear a single beep; reopen and close the front cover.
4. Press the FEED button until you hear a single beep and release it. The printer will print
the setting for COMMAND TYPE. Continue to press the FEED button until the printer
prints “Command Type -CBM2”.
5. Press and hold the FEED button until you hear a single beep followed by three quick
beeps.
6. Press the FEED button until you hear a single beep and release it. The printer will print
the setting for NUMBER OF COL. Continue to press the button until the printer prints
“Number of Col. –42/35”.
7. Press and hold the FEED button until you hear a single beep followed by three quick
beeps.
8. Press the FEED button until you hear a single beep and release it. The printer will print
the setting for FONT SELECT. Continue to press the button until the printer prints “Font
Select -7*9”.
9. To save the configuration, open and close the front cover.