Unitec POS4000 - Manual (Page 48)

P O S 4 0 0 0
Document Number: POS4010 28
Document Title: Remote Code POS4000 Installation and Operations Manual
3 . 1 . 1 0 . 1 S e t U n i t N u m b e r
This command is used to set the unit number of the POS4000.
To select this command, scroll through the Multiple Unit sub-menu until "Set Unit Number"
appears and then press [ENTER].
Example to set the unit number of a POS4000 as 3:
[CMD]
[SYSTEM SETUP]
[3]
(password 3)
[MENU UP/DOWN] until "Multiple Unit MENU->" appears
[ENTER]
[MENU UP/DOWN] until "Set Unit Number" appears
[ENTER]
[3]
[ENTER]
Note: The default unit number is 1.
3 . 1 . 1 0 . 2 C o n t r o l l e r / R e m o t e
This command is used to designate a POS4000 main console as either a controller console or a
remote console.
To select this command, scroll through the Multiple Unit sub-menu until "Controller/Remote"
appears and then press [ENTER].
Example to designate a main console as a REMOTE Console:
[CMD]
[SYSTEM SETUP]
[3]
(password 3)
[MENU UP/DOWN] until "Multiple Unit MENU->" appears
[ENTER]
[MENU UP/DOWN] until "Controller/Remote" appears
[ENTER]
[2]
to select Remote
[ENTER]
Note: The default is for the console unit to be a controller.
3 . 1 . 1 0 . 3 S e t N u m b e r o f B a y s a n d C o n s o l e s
This command is used to define the number of customer interfaces (carwash bays) and remote
POS4000s that are present at a site.