Unitec POS4000 - Manual (Page 61)

P O S 4 0 0 0
Document Number: POS4010 41
Document Title: Remote Code POS4000 Installation and Operations Manual
The process for changing the Footer message is identical to that used to change the Header
message.
Example to change footer message:
[CMD]
[SET MESSAGES]
[1]
(password 1)
[ENTER]
[MENU UP/DOWN] until "Change Footer Msg." appears
[ENTER]
(Example to change footer message cont.)
[9][9] (to change all lines of message)
[ENTER]
[T][H][I][S][ ][I][S][ ][A][ ][T][E][S][T]
[ENTER]
* (repeat for each line)
*
[ENTER]
3.6.4 Print Current Message Configuration
This command is used to generate a printout of the current header message, postscript
messages and their assignments and footer message. To execute this command, scroll through
the Set Messages secondary menu until "Print Message Config" appears and then press
[ENTER].
Example to print current message configuration report:
[CMD]
[SET MESSAGES]
[1]
(password 1)
[ENTER]
[MENU UP/DOWN] until "Print Message Config" appears
[ENTER]
3.7 Set Passwords
This command allows you to change the passwords that control access to specific commands.
To select this command press the [CMD] key followed by the [PASSWORDS] key. You will be
prompted to enter password 3. Once the correct password is entered, you can scroll through the
secondary menu that follows:
• Change Password 1
• Change Password 2
• Change Password 3
• Change Password 5
• Change Serial Pass (password used for access via serial port)
To execute one of the secondary commands, scroll through the secondary menu until the
command of interest is displayed, and then press the [ENTER] key.