Unitec POS4000 - Manual (Page 24)

P O S 4 0 0 0
Document Number: POS4010 4
Document Title: Remote Code POS4000 Installation and Operations Manual
1.4 Wash Select II POS System
The Wash Select II may be configured to interface to a POS4000 in order to be activated by
Codes sold at one or multiple POS4000 units. This is how a Wash Select II/POS is configured to
operate. Any Wash Select II may also be upgraded in the field to interface to a POS4000 either
by direct wires or via RF (Radio Frequency) interface.
For Remote Code functions, make sure washes and options programmed in the WSII are same
as ones programmed in the POS4000 or the code will be declined. For example, a code sold
with an option will not be accepted in a WSII with optioning disabled. Also verify the date
settings on the WSII and the POS4000 involved to make sure they are accurate because the
Remote Code function depends on them.
Upgrading a Wash Select II to interface to a Remote Code POS4000 requires the following:
• Version 5.50 or greater software installed into the Wash Select II
• POS4000 with Version 8.24 or greater installed.
• Wash Select II 485 communications module. This plugs into the top left corner of
the Wash Select II CPU board.
• RF transceivers (Optional if your cable connection between the POS4000 and
Wash Select II is not feasible)
The Wash Select II is mostly configured at the Wash Select II entry system. Most of the entry
system settings in the POS4000 are not used by the Wash Select II. You must configure the
Wash Select II to accept the Wash names and Prices of the POS4000.
Here is a list of functions and features that must always be programmed at the Wash Select II
entry system:
• Credit system
• Speech recordings and settings
• Receipt Header
• Wash Interface (Remote Code, Relay Stacking, Relay Latching, Out of Service
etc.)
• Customer Interface (Upgrades, forced selection, Customer stacking etc…)
• Paging functions
• Cash and Token settings.
• System time, Printer config, Site ID, and Service Phone #
• VIP Wash Coupons™
• Passcodes & Passcards
Note: You must program the names and prices directly into the Wash Select II and they must
match the POS4000 names and prices in order for Remote Codes to function properly.
1.4.1 Enable and Setup Remote Code
Before starting using remote code, make sure these requirements are met: on the WSII:
• Expansion memory installed
• Credit Mode is NOT set to credit mode 3