Unitec POS4000 - Manual (Page 43)

P O S 4 0 0 0
Document Number: POS4010 23
Document Title: Remote Code POS4000 Installation and Operations Manual
[3][2]
[ENTER]
3.1.9 External POS MENU->
Note:
This command is used to configure an OPTIONAL FEATURE of the POS4000. If this
feature is not present in your system, you will not be able to execute these commands.
This sub-menu is used to configure the external Point-of-Sale (POS) capabilities of your system.
It contains the following sub-menu items:
• Set POS Offset (direction and amount)
• Set EXT. POS Type
• Set POS MAX WASHES (for special circumstances only)
• Set Send Code age (for certain EXTPOS units only)
• Set Reverse order (to allow pumps to have wash 1 most expensive)
• Set Default Discounts
To execute one of the sub-menu commands, first select "External POS MENU->" from the
SYSTEM SETUP menu, and then scroll through the sub-menu until the command of interest is
displayed and then press the [ENTER] key.
Note that with the Optional Remote Extpos Connection Software, the master and each
secondary console can be set to interface to a different External POS system using different
configuration settings.
3 . 1 . 9 . 1 S e t P O S O f f s e t
Note: This feature is for use with POS 1, 2 and 3.
This command is used to convert an external POS system's wash "type" or "level" to a
POS4000 program or group key.
To select this command, scroll through the External POS sub-menu until "Set POS Offset"
appears and then press [ENTER].
Example to set the POS Offset as 5 UP:
[CMD]
[SYSTEM SETUP]
[3]
(password 3)
[MENU UP/DOWN] until "External POS MENU->" appears
[ENTER]
[MENU UP/DOWN] until "Set POS Offset" appears
[ENTER]
[1][ENTER]
to select direction UP
[5][ENTER] to select amount of offset as 5