Unitec POS4000 - Manual (Page 58)

P O S 4 0 0 0
Document Number: POS4010 38
Document Title: Remote Code POS4000 Installation and Operations Manual
[CMD]
[SERVICE]
[6][2][7][4][7]
(password 4)
(Example to set non-printer mode cont.)
[MENU UP/DOWN] until "Set print to Display" is displayed
[ENTER]
[1] [ENTER]
to enable printing customer codes to display
3.4.5 Display POS Diags
This command is used in troubleshooting the connection to the external POS
device. Enabling it will cause the POS4000 display to show diagnostic messages
that may be useful to technicians or the Engineering division of Unitec. Do not
use this command unless directed to do so by a qualified person.
Example to configure the displaying of POS diagnostic messages:
[CMD]
[SERVICE]
[6][2][7][4][7]
(password 4)
(Example to enable the setting)
[MENU UP/DOWN] until "Display POS Diags" is displayed
[ENTER]
[1] [ENTER]
to enable the displaying of POS diagnostics
3.5 Clear Audit Counts
This command prints an accounting report like the list counts command, but it also clears the
selected counter level after the report is printed.
Three sets of the counters (shift, manager, and auditor) can be cleared. Each level requires a
different password to clear. The shift, manager and auditor counts are cleared using passwords
1, 2, and 5 respectively.
Example to clear the Manager level:
[CMD]
[CLEAR REPORTS]
[MENU UP/DOWN] until "Clear Manager Counts" appears
[ENTER]
[2]
(password 2, depends on level requested)
[ENTER]
3.6 Set Messages
This command allows you to define the Header Message that is printed at the top of each ticket,
the footer message that is printed at the bottom of each ticket and the Postscript messages that
are optionally printed at the bottom of tickets.