Unitec POS4000 - Manual (Page 25)

P O S 4 0 0 0
Document Number: POS4010 5
Document Title: Remote Code POS4000 Installation and Operations Manual
• POS LINK is not set to POS4000 Link
To enable the Remote Code function in the WSII:
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2. Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the "Wash Interface" option is displayed. Press the (*) key to
enter.
3. Use the (3) key to scroll until the "Remote Code" option is displayed. Press the (*)
key to enter.
4. “Use Remote Code?” will be displayed. Press (1) for yes and (3) for no. Press (*)
to enter.
Once enabled, go to Parameter Setup and enter the following information:
• IDs of POS Where Codes Sold: enter the ID of the POS4000(s) where the code is sold.
Up to 4 POS4000 IDs are supported. Default = 1
• Code Expiration: number of days a code is good after purchase from1 to 60 days.
Default=14
• Daily Code limit: maximum number of codes can be issued per day from 10 to190.
Default = 100
• Security Code: used to decrypt the wash code and is up to 7 digits. Using default value
or simple numbers like “1234567” or “3333333” is discouraged.
Note:
After completing the items, the settings are printed out. Keep printout as the same settings are
entered into the POS4000(s).
For any Secondary Units connected to the Primary unit and using remote code, enable Remote
Code on that unit too. However, no parameters need to be programmed on those units.
1.4.2 Remote Code Utilities
To access the Remote Code utilities, go to the Wash Interface menu.
• Print Used Codes: Get a printout of the redemption of the codes sold on a
particular day. Enter the date when the code issue date in the MMDD format
(leading 0 required), then press ‘*’. Codes redeemed in any secondary units
connected are included too.
• Clear Used Codes: To clear the code redemption history.
1.4.3 Changes to Code Entry on Wash Select II
When Remote Code is enabled, these features apply to all codes entered in the WSII keypad:
• DO NOT use 6 or 7 digit codes for fleet accounts when using Remote Code. The
Code Length may conflict with codes sold at the Remote Code POS4000.
• Zeros in code no longer serve as the Enter key, it can appear in any position for
any code.