Rockwell Automation 5370-UPK CVIM USER-PAK Option - Manual (Page 101)

Chapter 8
Defining Strings for Serial Ports and Viewports
8–25
Selecting the Toolset(s)
The string will be processed at the completion of each inspection for each of
the toolsets selected. You select the toolset(s) by selecting the appropriate
Print for TS . . . box(es) on the Event menu.
Print for TS . . . boxes (both boxes
selected)
To select or deselect either Print for TS . . . box, pick either box to toggle
between selected and deselected.
If you select neither box, you effectively disable the string – it will never be
sent (unless “forced” – see the Force Print command in Appendix C).
Serial port: The toolset selection determines which toolset(s) the string will
be processed for.
Viewport: If the Display Page menu selection (see “Selecting Display
Pages and Page Numbers” in Chapter 7) for the viewport shows both toolsets
selected, both of the
Print for TS . . . boxes on the Event menu are enabled.
In this case, each Print for TS . . . box can be used to enable or disable the
string display for each toolset.
If a viewport is displayed for only one toolset (as determined by the Display
Page menu selection for the viewport), strings within it cannot be displayed
for the other toolset. In this case, only the corresponding Print for TS . . .
box on the Event menu is enabled; the enabled Print for TS . . . can be used
only to enable or disable the string display for the selected toolset.