Rockwell Automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardPLC Controllers - Manual (Page 46)

Publication 1753-PM001A-EN-P - November 2005
3-6 Create a GuardPLC Project
Create Signals in the Signal Editor
1. To open the Signal Editor, choose Signals > Editor from the
Hardware Management menu bar.
2. Create 3 new signals, START, STOP, and MOTOR:
a. Left-click on New Signal in the Signal Editor. Type START in
the Name field and press the Enter key.
b. Left-click on New Signal again. Type STOP in the Name field
and press the Enter key.
c. Left Click on New Signal again. Type MOTOR in the Name
field and press the Enter key.
Connect Signals to I/O
Terminals Connect signals to I/O by dragging the signals from the Signal Editor
to the Input or Output tabs of the Connect Signals dialog.