Rockwell Automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardPLC Controllers - Manual (Page 111)

Publication 1753-PM001A-EN-P - November 2005
Configure the GuardPLC OPC Server B-5
5. Choose the Outputs tab. Drag DI1 from the Signal Editor to the
Outputs section of the OPC Signal Connections window.
6. Close the OPC Signal Connections window and the OPC-Server
Resources Editor.
7. Completely expand the G16OPC01 tree. Right-click
[1] DI 20 and choose Connect Signals.
8. Drag DI1 from the Signal Editor to DI[01].Value Signal field.
9. Close the DI1 Signal Connections window.
10. Right-click [2] DO 8 and choose Connect Signals.
11. Choose the Outputs tab.
TIP
Input and Output are identified from the
controller’s perspective. Therefore, output
means signals sent out from the GuardPLC
1600 controller and input means signals sent in
to the GuardPLC 1600 controller.