Rockwell Automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardPLC Controllers User Manual
Page 14
Publication 1753-PM001A-EN-P - November 2005
1-4 Connect to the GuardPLC Controller
Change the IP address of your programming terminal running RSLogix
Guard PLUS! software so that the GuardPLC controller and
programming terminal can communicate on a local network.
To change the IP address:
1. In Windows 2000, choose Start>Setting >Control Panel>Network
and Dial-up Connections.
2. Open Local Area Connections and click Properties. Select TCPIP
and click Properties.
3. Set the General TCP/IP Properties as shown below.
4. Confirm your settings by clicking OK in both dialog boxes.
TIP
If you suspect the GuardPLC controller has the
factory-set default IP address of 192.168.0.99 and the
default subnet mask of 255.255.252.0, set your
programming terminal’s IP address to 192.168.0.98
with a subnet of 255.255.252.0 to establish
communications.