Rockwell Automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardPLC Controllers - Manual (Page 11)

1 Publication 1753-PM001A-EN-P - November 2005
Chapter
1
Connect to the GuardPLC Controller
In This Chapter
Connect to the Controller
via RSLogix Guard PLUS!
Software You connect the controller to the programming terminal via an
Ethernet port on the controller. The programming terminal must have
an Ethernet port or Ethernet communication card.
To directly connect the programming terminal to the controller, use a
cross-over Ethernet cable. The GuardPLC 1600 and 1800 controllers
feature auto-sensing ports so that a cross-over or straight-thru cable
may be used.
Connect to a GuardPLC 1200 Controller
For information about See page
connecting to the controller via RSLogix Guard PLUS 1-1
going online with the GuardPLC controller 1-5
configuring the programming terminal 1-19
login dialog 1-20
determining the IP address and SRS of the controller 1-21
changing the SRS of the controller 1-22
changing the IP address of the controller 1-23
PLC
1200
Ethernet port
(on the bottom of the controller)