Chapter summary, Go on line – Rockwell Automation 1738-ADNX ArmorPoint I/O DeviceNet Adapters User Manual
Page 66
Publication 1738-UM001A-EN-P - February 2005
5-6 Add the ArmorPoint DeviceNet Adapter to the DeviceNet Scanner’s Scanlist
Go On Line
Follow these steps for the adapter to go on line:
1. Use the Network pulldown.
The software prompts you to save your configuration changes.
2. Choose your adapter’s network as shown below.
To learn how to add the ArmorPoint DeviceNet adapter to the
scanner’s scanlist, refer to the Quick Start section, Appendix B.
Chapter Summary
In this chapter, you learned how to configure the adapter.
1. Click on Network.
2. Click on Online.
Click Yes.
Select the DeviceNet network.
This selection accesses the PointBus
to configure the adapter on the
DeviceNet network.
Click OK to apply the data
to your adapter.
This manual is related to the following products: