Rockwell Automation 1738-ADNX ArmorPoint I/O DeviceNet Adapters - Manual (Page 20)

Publication 1738-UM001A-EN-P - February 2005
2-4 What Is the ArmorPoint DeviceNet Adapter?
4. Configure the Primary DeviceNet Network
Finally, you must configure the adapter for communication with a
master (e.g., 1756-DNB).
For more information on configuring the DeviceNet network, see
Chapter 5, Add the ArmorPoint DeviceNet Adapter to the DeviceNet
Scanner’s Scanlist.
You must understand all of the adapter’s features to effectively use it
in your ArmorPoint I/O system. Keep these four steps in mind as you
read this manual:
1. Set Subnet/Backplane Baudrate
2. Set Subnet/Backplane I/O Module Addresses
3. Configure the Subnet I/O
4. Configure the Primary DeviceNet Network