Rockwell Automation 1738-ADNX ArmorPoint I/O DeviceNet Adapters - Manual (Page 58)

Publication 1738-UM001A-EN-P - February 2005
4-6 Configure the DeviceNet Scanner Subnet
Use this pull-down menu to
choose a Memory type.
The memory type
corresponds to an I/O
connections on DeviceNet.
Set the starting byte for I/O mapping.
Click Advanced to edit the advanced
mapping parameters, as shown below.
Highlight a module and click Unmap to
unmap it.
Click Options to edit the automap
options, as shown below.
Set Map From parameters here.
Set Map To
parameters here.
Click Close when finished.
Click Apply Mapping to apply
changes and leave the screen open.
Choose a
Data
Alignment
and click
OK.
Use this pull-down menu to
choose a memory type. This
corresponds to I/O on the
primary DeviceNet.
Set the starting byte for I/O
mapping here.
Click Advanced to edit the advanced
mapping parameters.
Highlight a module and click Unmap to
unmap it.
Click Options to edit the automap
options.
Note that the Advanced Mapping
and Options windows are the same
for output modules as those shown for
input modules. See above for an
explanation of these windows.
The bytes mapped last will
determine sizes on the
primary DeviceNet.
Input window
Advanced Mapping window
accessed from Input window
Automap Options window
accessed from Input window
Output window