Rockwell Automation MV SMC Flex Motor Controller (for Series K or later) - Manual (Page 99)

Rockwell Automation Publication 1560E-UM051F-EN-P - June 2013 89
Chapter
6
Options
Overview The SMC Flex controller offers a variety of unique control programming and
communication options that provide enhanced capabilities (refer to
Chapter 1
for brief descriptions of each option).
Human Interface Module The control buttons available with the Bulletin 20-HIM Human Interface
Modules are compatible with the SMC Flex controller’s control options. The
following table details the functionality of each button with regards to each
option.
Notes:
1. The logic mask port must be enabled prior to initiating control commands
to the SMC Flex controller. Refer to
Control Enable on page 106 of
Chapter 8 for instructions.
2. The control terminals must be wired according to Figure 36 on page 62
and Figure 37 on page 63 .
TIP Only one option can reside in a controller.
Option Action Operation
Standard
Soft Stop
Current Limit
Full Voltage
Linear Speed The green start button, when pressed, will commence
motor acceleration to full speed.
The red stop button, when pressed, will provide a coast
stop, and/or reset a fault.
The jog button, when pressed, will initiate the
programmed maneuver.
Preset Slow Speed The green start button, when pressed, will commence
motor acceleration to full speed.
The red stop button, when pressed, will provide a coast
stop.
The jog button is not active for Preset Slow Speed.
* Slow Speed cannot be operated via the HIM.
II
O O
Sel Jog
II
O O
Sel Jog