Lenze L-force I/O System 1000 - Manual (Page 97)

2.0 EN - 11/2010
L
97
L-force Controls | I/O System 1000
Index
R
Receive objects 83
Restore All Parameters (0×1011/1) 64
Running number - EPM-S207 69
Running number - EPM-S310 69
S
Safety instructions 9
Save All Parameters (0×1010/1) 64
Save, parameter settings 64
Save, station structure 64
Setting the parameters for "Analog input" 43
Setting the parameters for "Analog output" 44
Setting the parameters for "Digital input" 31
Setting the parameters for "Digital output" 36
Setting the parameters for "DO2 PWM" 40
Setting the parameters for AIx 12Bit 43
Setting the parameters for AIx 16Bit 43
Setting the parameters for AOx 12Bit 44
Setting the parameters for counter modules 46
Setting the parameters for DI2 TimeStamp 32
Setting the parameters for DIx NPN, DC24V 31
Setting the parameters for DIx, DC24V 31
Setting the parameters for DO2 Timestamp 37
Setting the parameters for DOx NPN, DC24V 36
Setting the parameters for DOx, DC24V 36
Setting the parameters of the bus coupler 30
Setting the parameters of the SSI module 60
SSI module, master mode 62
SSI module, monitoring operation 63
SSI module, operating mode 62
State transitions, NMT 89
Station structure, configuring 14
Station, behaviour after switch-on 13
Station, establishing a connection via the CAN system
bus 23
Status word - EPM-S600 73
Status word - EPM-S601 74
Status word - EPM-S602 75
Status word - EPM-S603 76
Status word - EPM-S620 71
Structure of safety instructions 9
Switch-on, behaviour of station 13
T
Target group 6
Telegram structure, NMT 88
Terminology, used 8
Ticker value - EPM-S207 69
Transmit objects 85
Tree topology, in the project view 27
V
Validity, information on 6