Lenze L-force I/O System 1000 - Manual (Page 64)

L-force Controls | I/O System 1000
Parameter setting
Save parameter settings and station structure
64
L
2.0 EN - 11/2010
6.8 Save parameter settings and station structure
6.9 Load Lenze setting
If the read-in station structure is not identical to the saved station structure after the I/O
system 1000 is switched on, the CAN bus coupler module reports an error ("SF" LED is
blinking).
Parameter | Name:
0×1010/1 | Save All Parameters
Parameter settings and station structure are saved to the EEPROM of the bus coupler.
Selection list
(Lenze setting printed in bold) Information
0 No function Function acc. to CANopen (communication protocol
DS301/DS401)
1702257011 Save
Parameter | Name:
0×1011/1 | Restore All Parameters
The parameter settings are reset to the Lenze setting in the EEPROM of the bus coupler.
Selection list
(Lenze setting printed in bold) Information
0 No function Function acc. to CANopen (communication protocol
DS301/DS401)
The Lenze setting is accepted by switching the supply
voltage off and on. All settings that have been saved
before are deleted from the EEPROM of the CAN bus
coupler.
1684107116 LOAD