Lenze L-force I/O System 1000 - Manual (Page 24)

L-force Controls | I/O System 1000
Communication via system bus (CAN)
Setting the communication path
24
L
2.0 EN - 11/2010
4.2 Setting the communication path

How to configure an online connection via system bus (CAN):
1. Go to the Project view and select the I/O system 1000 to be connected online:
2. Select the OnlineSet communication path and go online command to open the
Communication path dialog box.
3. In the Communication path dialog box, select the "CAN" entry from the Bus
connection list field.

Note!
The communication settings need to be made only once when the connection to
the device is established for the first time. If the Go online command is executed
again, the communication path dialog box will not be displayed again, and an
online connection will be established immediately via the bus connection set for
the device.
To change a communication path that has already been set, go to the Online
menu and execute the Set communication path and go online command.