Lenze L-force I/O System 1000 - Manual (Page 28)

L-force Controls | I/O System 1000
Navigation
Tabs of the modules
28
L
2.0 EN - 11/2010
5.2 Tabs of the modules
The different tabs in the workspace show the properties and settings of the module
currently selected in the Project view and can also be changed here.
 Depending on the module selected in the Project view, different tabs are available in
the workspace.
 When clicking a tab located in the upper position of an index card, you bring the
corresponding index card to the fore.
CAN bus coupler module
 The Configuration tab shows the composed station.
 The Ports tab shows the input and output ports of the CAN bus coupler module.
 The All parameters tab lists all objects for parameterising the configured I/O system
1000.
 The Properties tab shows project information and catalogue information of the CAN
bus coupler module.
 The Documentation tab serves to add notes and documents in electronic form to the
CAN bus coupler module.
Electronic modules
 The Parameters tab lists all parameters of the electronic module.
– Parameterising digital modules:
Polarity of the control signals, error state for digital output modules.
– Parameterising analog modules:
Signal functions, error state.
 The Properties tab shows project information and catalogue information of the
electronic module.
The Documentation tab serves to add notes and documents in electronic form to the
electronic module.