Lenze 931W User Manual
Ä.1kjä, Servo drives 930, L-force drives
This manual is related to the following products:
Table of contents
Document Outline
- K-HB 13.0001-EN
- Document history
- Contents
- 1 Preface
- 2 Safety instructions
- 3 Technical data
- 4 Electrical installation
- 5 Commissioning
- 6 Control word and status word ( Profidrive state machine)
- 6.1 General information
- 6.2 Control word
- 6.3 The status word ( ZSW)
- 6.4 The Profidrive state machine
- 8.10 Data type -service parameters ( PNU 105)
- 8.11 Data type -PROFIBUS parameters ( PNU 106)
- 8.12 Data type status ( PNU 1000)
- 8.13 Data type info ( PNU 1001)
- 8.14 Data type options ( PNU 1002)
- 8.15 Overview of all PNUs
- 7 Parameter channel ( PCV mechanism)
- 8 Parameter numbers
- 8.1 Explanation of the parameter numbers
- 8.1.1 Node address ( PNU 918)
- 8.1.2 Parameter change rights ( PNU 927)
- 8.1.3 Control authority ( PNU 928)
- 8.1.4 Selector switch for operating mode ( PNU 930)
- 8.1.5 Selector switch -control word bit 8 ( PNU 931)
- 8.1.6 Selector switch -control word bit 9 ( PNU 932)
- 8.1.7 Selector switch -control word bit 11 ( PNU 933)
- 8.1.8 Selector switch -control word bit 12 15 ( PNU 934 937)
- 8.1.9 Selector switch -status word bit 8 ( PNU 938)
- 8.1.10 Selector switch -status word bit 11 ( PNU 939)
- 8.1.11 Selector switch -status word bit 12 ( PNU 940)
- 8.1.12 Selector switch -status word bit 13 ( PNU 941)
- 8.1.13 Selector switch -status word bit 14 ( PNU 942)
- 8.1.14 Selector switch -status word bit 15 ( PNU 943)
- 8.2 Device-specific parameter numbers
- 8.3 Overview of the device-specific active parameters
- 8.4 Overview of the device-specific passive parameters
- 8.5 Data type -travel data record ( PNU 1 to 100)
- 8.6 Data type -reference parameter ( PNU 101)
- 8.7 Data type -IO settings ( PNU 102)
- 8.8 Data type -control parameters ( PNU 103)
- 8.9 Data type -system parameters ( PNU 104)
- 8.1 Explanation of the parameter numbers
- 9 Troubleshooting and fault elimination
- 10 Appendix
- 11 Index